Including

---------------------------------------------------

• 1 x set orings for the deck and chimney.
• 1 x menelaus drip tip polish.
• 1 x pouch.
• 1 x box.
• 2 x extra screws for the coil.

   A FEW WORDS ABOUT MENELAUS RTA

Menelaus it has a special deck made for easy setup and rich liquid supply achieved by two posts, which are also responsible for holding the cotton in place. The draw is quite rich since cotton is slightly denser compared to the older versions of Phenomenon. The Aiolos chimney has the possibility for fast extraction without presence of hot steam, even with wires out of the suggested setups. Also delivers a dried version of any tobacco liquid, as it incrase its flavors up to 30%. Clearly balanced mtl in terms of air, since there are two leveled holes of 0.75 mm beneath the coil. The capacity of 4 ml is good enough for an mtl RTA..

Refilling is very easy from a port on the top of the polycarbonate tank.Turning the steel air ring clockwise, gives the opportunity to micro-adjust the air intake, depending on your tastes. It should be mentioned that the included mouthpiece (Caminor) is one of the most sought after drip tips in the GUS-MOD series, for its balanced round draw and the increase of the taste to an amazing degree of satisfaction…

   ABOUT SETUP COIL / COTTON

• • 1
    A 6 wrap coil of 0.35mm diameter wire, wrapped around a 2 mm core is quite potent in taste and in vapor production, providing rich aroma.
    Pay attention to the height and orientation so that it does not touch the top of the screws in order to avoid a short circuits.
  • 2
    Here you can see the height and the ideal distance from the deck.
  • 3
    Pass the cotton inside the core of the coil quite tightly, to the point that the deck would be dragged as soon as you pulled the cotton.
    
  • 4
    Cut the cotton right and left sides first, according to the heel of the deck.
  • 5
    Lightly fluff the cotton with the tip of your tweezers or a pair of scissors.
  • 6
    Wet the cotton with the liquid of your choice, as this will help with placement afterwards.
  • 7
    Flatten the cotton in palace with a pair of scissors and a rolling pin.
  • 4
    Cut the cotton right and left sides first, according to the heel of the deck.
  • 8
    Cut the excess, as this will give you the right length in the predetermined sides of the cotton.
  • 9
    the image you will have after cotton flattening, side profile.
  • 10
    the image you will have after cotton flattening, from above.
  • 11
    With your tools, press the edges of the cotton to the right and left, trying to form an open cylinder, roughly like the shape of cinnamon.
  • 12
    Lower the cotton lengthwise by breaking it at an angle, so that it presses lightly on the deck.
  • 13
    As we can see the inner walls of the cotton do not come in contact with the top of the screws.