Including
---------------------------------------------------
- 1 x box.
- 1 x pouch GUS.
- 4 x pieces spare fuses.
- 1 x brass ring for the kick.
Owner Manual
Package
When you receive the Kiss summer edition, it should be in the box and accompanied
by an extra pouch.
Opening the package we will find the telescopic model and its spare parts
fuses and brass rings for the kick.
Parts of the Kiss Summer
Our telescopic if we re-emerge it consists of two tubes internal external
the switch and the top cap with the pole and the extensions.
Batteries
In our telescopic we can choose between the three sizes from the batteries
that are on the market 18650-18500-18350.
Tubes
Upper and lower tubes of the telescopic.
Apply the height of the tubes according the battery you have installed
screw each other between the two tubes to the point that will be needed depending
on the battery we have placed.
Install the switch
By locking the switch in the bottom tube it is important that the housing
of the switch fits perfectly with the tube.
Install the battery
We place the battery with the positive pole on the upper side to make contact
with the 510's ship we always keep our battery condition mainly for external
shoelaces and flat faces to its poles.
Adjust the tubes
Leaving a gap like the photo between the battery and the bottom tube makes it easy
for us to correctly screw the switch.
Switch Locked position
Unsrew the SS nut we lock the switch
Switch
The switch it is clockwise - as you screw the switch, take the most of the power and contact the housing to the tube
and not the lock ring with the housing.
Housing - Lock ring
We check carefully to have the right gap between housing and lock ring.
Adjsut the rta
After we have unscrewed the top cap from the tube we will try to properly adjust our RTA -RDA.
Adjust the rta
After we have unscrewed the top cap from our tube we observe a tiny nut playing
the roll of the positive pole where it will come in contact
with the positive steam of the atomizer for the first to unscrew it minimally
to leave the appropriate gap to warm up our RTA/RDA and not has a gap.
Adjust the rta
To begin with, let the possitive pole of the RTA/RDA protrude from the threads.
Screw the top cap to the point of embracing the two surfaces .
Adjust the rta
The right contact between rta and top cap.
Adjust the rta
At this point we turn our brass pole right in order to make proper contact
with the pole of our RTA/RDA.
Adjust the tubes
We are ready to adjust the top cap to the tube so we leave
a lot of space for our battery and the top surface of tube.
Adjust the top cap
Screw the top cap loosely on the tube, you will not need to tighten enough.
Adjust the tubes
Screw the two tubes together to make proper contac.
Final result
Our telescopic it is ready for use.
(screw the lock ring clockwise to can fire).